I have a Resmed Air Sense 10 and the water heat stopped working. I tried cranking it up and still nothing. I wanted to find out if it is the heating element, the temperature sensor, or the power going to it. I took off the cover and there are a number of test points (electrical) available. However I...

I switched masks and the new one has a magnetic fastener, Resmed Airfit. That makes it thicker than the old one. The fastener sits over the jaw joint. I now have pressure sensitivity at that point, lower teeth. It only bothers me when I brush my teeth. It tends to be the soft tissue. My dentist was ...

Has anyone tried to carry on distilled water through TSA and of course I need more than 3.4 Oz. There is an exemption for medical liquids but I can't tell if distilled water qualifies. I can't check a bag so I have to carry it on if I am going to take it. It will be too awkward to buy some there. I ...

palerider wrote: there is no prescription part of a mask... the only thing that requires an rx is a whole mask.

wisp frames are all over ebay, btw. (49 results at the moment.)

Right you are. It has been a while since I checked. I even found a complete mask. I thought that was against the rules.
Lee

I don't think they can sell the frame on Ebay. I think that is considered the prescription part of the mask.
I think next time I will be looking at the ResMed Swift FX Nano It seems it might work for me.
I have contacted Respironics. We will see if they have anything to say.
Lee

In most cases, you can use the headgear from a different mask or a "generic" headgear. From what I see, this mask should not be an exception. It seems that this mask can be used with the clips or the headgear can be threaded directly through the holes. If the problem is with the clips, try threadin...

Is anyone else experiencing breakage in the Wisp mask? I have been using the Wisp for a couple of years. So far on 3 of them the headgear has snapped in two. Two of them broke just past 6 months so I just got a new one. One broke just before 6 months so for a week I went back to the old brand I stil...

I just bought a AirSense 10 (used). I put my watt meter on it to see how it compared to my old one. The old one had a Purge mode after it was turned off. So I unplugged it every morning. Why waste electricity to run it when I am not using it. Since I wasn't using humidity I didn't need the purge. I ...

I haven't started using it yet. I am still airing it out. I am using a rental. I know the plastic absorbed odors. I am trying to get it to dissipate the quickest. I was hoping agitating it would knock them free quicker. I got some Ozium and it helped a bit.

I disagree with your MAIN premise. I don't have a spouse so my main reason is my health. I can't live without it. I gained over 3 inches on my neck before I got one. However I realize YMMV and each to his own.

The image is too small to read the numbers. Are the O2 marks 5% increments? When I did something similar years ago what interested the doctor was not the large dip but smaller more regular dips like you can sort of see on night 2 that indicate apnea. However I don't think yours drop below 90% so not...

I put my update at the top of the thread.
Lee

For 50 years I was a mouth breather at night. After my nasal surgery I was finally able to close my mouth but habits are hard to break. I tried lots of things. I used a piece of tape, sometimes two, vertically to hold it closed finally and it worked. I wanted to be able to rip it open in my sleep if...

To me it seems the filter seal is not that good so I worry about it leaking once the filter gets a little clogged. However when I search for filters some say 2 1/8 x 1 3/8 and others say 2 1/8 x 1 7/16. Most sites show the larger size and say they are compatible. But I am not convinced that I would ...

The filter is cheap which is why I will flush it with a clean one and then throw that one out.
I want to try the Ozium and don't want to breath that.
Lee