Bipap problems

General Discussion on any topic relating to CPAP and/or Sleep Apnea.
User avatar
Sludge
Posts: 953
Joined: Wed Dec 04, 2013 4:36 am

Re: Bipap problems

Post by Sludge » Sat Feb 22, 2014 3:53 am

Sludge wrote:
Sludge wrote:... this thing is about as helpful as a rock.
OK, a rock that can give big pressures.
And a very expensive rock.

Image
You Kids Have Fun!!

User avatar
robysue
Posts: 7520
Joined: Sat Sep 18, 2010 2:30 pm
Location: Buffalo, NY
Contact:

Re: Bipap problems

Post by robysue » Sat Feb 22, 2014 11:44 am

Sludge wrote:
However, if you're treating OSA/CSA etc., note the absence of virtually anything that would be useful, so for sleep apnea, this thing is about as helpful as a rock.
Asking for clarification: What things ARE useful for treating Sleep Apnea?

Is the problem that the VPAP™ COPD doesn't record data or is there something I'm missing???

_________________
Machine: DreamStation BiPAP® Auto Machine
Mask: Swift™ FX Nasal Pillow CPAP Mask with Headgear
Additional Comments: PR System DreamStation and Humidifier. Max IPAP = 9, Min EPAP=4, Rise time setting = 3, minPS = 3, maxPS=5

User avatar
mikebrant97
Posts: 33
Joined: Thu Feb 20, 2014 7:21 am
Location: Port Townsend
Contact:

Re: Bipap problems

Post by mikebrant97 » Sat Feb 22, 2014 9:13 pm

So it's not the machine I need? ?????

User avatar
mikebrant97
Posts: 33
Joined: Thu Feb 20, 2014 7:21 am
Location: Port Townsend
Contact:

Re: Bipap problems

Post by mikebrant97 » Sat Feb 22, 2014 9:16 pm

I think I just wish I could live in in hyperbaric chamber. It would be simpler I think. N easier to put the mask on

User avatar
Sludge
Posts: 953
Joined: Wed Dec 04, 2013 4:36 am

Re: Bipap problems

Post by Sludge » Sun Feb 23, 2014 5:54 am

mikebrant97 wrote:So it's not the machine I need? ?????
I sincerely doubt it (it lacks any ability for auto options). Using NIV technology is the same as the 1985 approach to OSA.

Can you get the results of your titration and upload the data from the machine?

Lower esophageal sphincter pressure at the esophageal-gastric junction (the thing that creates the seal that prevents regurgitation) is ~ 20–25 cmH2O. If your BiPAP attack is 30/23 there's always going to be great risk for gastric insufflation, so you're going to need a plan to manage that. Do some stuff to prevent that (jack up the head of the bed, avoid large meals, etc.) but "IMHO" you should look for opportunities to reduce mean pressure where possible (that said, if you're on 30/23 you must be BAAAAADDDDD, so arbitrarily reducing would probably not be a good idea).

However, those pressures may only be necessary in specific situations, like supine REM, so positional therapy plus AutoBiPAP

http://www.healthcare.philips.com/pwc_h ... tfinal.pdf

might be a valid approach (that thing not only has high pressure capability but PS = 0. More on that later).

Also get rid of some LBs. I think that would really go a long way in pressure reduction > better treatment efficiency > better compliance > more weight reduction > better treatment efficiency...
You Kids Have Fun!!

User avatar
Sludge
Posts: 953
Joined: Wed Dec 04, 2013 4:36 am

Re: Bipap problems

Post by Sludge » Sun Feb 23, 2014 6:10 am

mikebrant97 wrote:I think I just wish I could live in in hyperbaric chamber.
So let's think about that. The obstructions would continue, and the arousal mechanism would be dampened by the supranormal oxygen levels (there'd still be a little breathing), but lactic acidosis would be greatly reduced cause your pO2 is like 1200 mmHg...

OK, let's do it!

If you can get $133,000 for the tube, I can I torrent the clinical manual.

Major dial wingin"!
You Kids Have Fun!!

User avatar
Sludge
Posts: 953
Joined: Wed Dec 04, 2013 4:36 am

Re: Bipap problems

Post by Sludge » Sun Feb 23, 2014 6:18 am

Also, if we go to a real OSA/CSA machine, we can get some of that BiFlex going to help immediately reduce Mean Pressure.
You Kids Have Fun!!

User avatar
Sludge
Posts: 953
Joined: Wed Dec 04, 2013 4:36 am

Re: Bipap problems

Post by Sludge » Sun Feb 23, 2014 6:45 am

Sludge wrote:Can you get the results of your titration...
Because another opportunity may be hiding in "hysteresis":
4.3.2.9 “Down” titration is not required but may be considered as an option (Consensus).

This recommendation and the following protocol is based on consensus agreement by the PAP Titration Task Force. As in the case of CPAP, a “down” titration is recommended for BPAP due to the “hysteresis” phenomenon (see Recommendation 4.2.2.8). If a “down” titration is implemented, the Task Force recommends at least one “up-down” BPAP titration (1 cycle) should be conducted during the night. “Down” titration of IPAP and EPAP is conducted when at least 30 min has elapsed without obstructive respiratory events. IPAP should be decreased by at least 1 cm H2O with an interval no shorter than 10 min, until there is reemergence of obstructive respiratory events. There is also limited evidence that an “up-down-up” titration protocol should be considered for CPAP (see Recommendation 4.2.2.8); an “up-down-up” titration protocol should also be similarly considered for BPAP.
You Kids Have Fun!!

User avatar
mikebrant97
Posts: 33
Joined: Thu Feb 20, 2014 7:21 am
Location: Port Townsend
Contact:

Re: Bipap problems

Post by mikebrant97 » Sun Feb 23, 2014 10:02 pm

It sends data via a modem that Ic cellular. I'm am trying to lose weight

User avatar
Sludge
Posts: 953
Joined: Wed Dec 04, 2013 4:36 am

Re: Bipap problems

Post by Sludge » Mon Feb 24, 2014 5:03 am

Right, they're using EasyCare Online:
ResMed’s EasyCare Online therapy monitoring is a comprehensive solution that empowers you to help patients achieve better therapy outcomes and manage their condition post-discharge.

• Usage reports make it easy to identify patients who are not following their treatment plan so you can proactively address issues.
• Critical respiratory parameters provide additional insight into patient therapy:
  • • Respiratory rate
    • Tidal volume
    • Minute ventilation
    • I:E ratio
Try shoving an SD20 Card in there to see what happens.

Do you have a real computer with an SD20 card reader?
You Kids Have Fun!!

User avatar
mikebrant97
Posts: 33
Joined: Thu Feb 20, 2014 7:21 am
Location: Port Townsend
Contact:

Re: Bipap problems

Post by mikebrant97 » Mon Feb 24, 2014 7:09 am

Yes I do but wouldn't it take special program to use the card for its information

User avatar
Sludge
Posts: 953
Joined: Wed Dec 04, 2013 4:36 am

Re: Bipap problems

Post by Sludge » Mon Feb 24, 2014 7:42 am

mikebrant97 wrote:Yes I do but wouldn't it take special program to use the card for its information
Yes, but you can get it (them) here or simply upload ALL the files on the SD20 card to Dropbox, where nosy users (like me) can view the data.
You Kids Have Fun!!

User avatar
DoriC
Posts: 5215
Joined: Sat Sep 13, 2008 9:28 pm
Location: NJ

Re: Bipap problems

Post by DoriC » Mon Feb 24, 2014 11:10 am

Mike, in case you're not aware yet, you're lucky to have Sludge on your case!

_________________
Mask: Mirage Quattro™ Full Face CPAP Mask with Headgear
Humidifier: HumidAire H4i™ Heated Humidifier
Additional Comments: 14/8.4,PS=4, UMFF, 02@2L,
"Do or Do Not-There Is No Try"-"Yoda"
"We are what we repeatedly do,so excellence
is not an act but a habit"-"Aristotle"
DEAR HUBBY BEGAN CPAP 9/2/08

User avatar
mikebrant97
Posts: 33
Joined: Thu Feb 20, 2014 7:21 am
Location: Port Townsend
Contact:

Re: Bipap problems

Post by mikebrant97 » Tue Feb 25, 2014 1:37 am

Ok I'll check it out in the morning. I just got home I'm glad. I just hope this thing is figured out soon n possibly y it makes my lungs ache

User avatar
mikebrant97
Posts: 33
Joined: Thu Feb 20, 2014 7:21 am
Location: Port Townsend
Contact:

Re: Bipap problems

Post by mikebrant97 » Tue Feb 25, 2014 8:00 pm

hi guys i jsut got home i downloaded the data how do i post it to you sir