the rubber bottom for my machine has worn off

[springman946]

hello I was just wondering how do I go about replacing the rubber bottom on my aircurve 10 ASV bi-pap machine.as you can see from the picture there is no longer a rubber pad under the machine over time the rubber padding just would peel off making the machine wobbly so i would just peed the rest of the padding off so it would not be so wobbly PROABLY WAS NOT A GOOD IDEA ON MY PART I would hate for it to slide off the nightstand at night while I am sleeping I went to my local hardware store and found some slip resistant adhesive and this is the ending result thanks everyone for your advice. it works like new again

IMG_1762.jpg (39.2 KiB) Viewed 561 times

[chunkyfrog]

I suggest you contact acbio.com, and ask if they will sell you a replacement pad.

[Julie]

Mouse pad at any Staples.

[zonker]

you can find peel and stick furniture pads that would do the same thing at either joanne's or michael's.

or amazon-

https://www.amazon.com/s?k=peel+and+sti ... nb_sb_noss

good luck!

[loggerhead12]

Toss some of that tacky rubber shelf liner under it.

[zonker]

Toss some of that tacky rubber shelf liner under it.

ooh, better.

and cheaper!

i like you.

[Grouchy Bear]

Mouse pad at any Staples.

+1

[chunkyfrog]

Craft foam and double stick tape from Walmart. (If you can figure out the self check outs)