REMSTAR PLUS PRESURE CHANGE NEED

[pietro]

Hi, I have a remstar plus and need to change the pressure from 10 to 11. Can anyone tell me the key sequence to do so.

I would like a good night sleep tonight!

[Suserbec]

Hi,
My husband needed his changed also but had to take the machine to the technician where he got it to get it done.
Hope this helps.

[True Life]

1. Disconnect the power cord from the back of the unit.
2. Press and hold down the power button (on right) and the ramp button (bottom left) at the same time.
3. While holding down these buttons, insert the power cord.
4. The machine will start in the setup mode.
5. Toggle through the various settings using the power button.
6. When you see the "10.0 cm", you will be at your main pressure setting value. You can also adjust the ramp time, ramp starting value and other parameters. Pay attention. The small graphics on the display will help you identify which parameters you are adjusting.
7. Use the heater button (above the ramp button) to increase the value or the ramp button the decrease the value.
8. Disconnect the power cord.
9. Reinsert the power cord. The unit should be reprogrammed.

Perseverance is the key. Depending on Jesus will give you the strength to persevere.