Why is that a problem? I didn't find a clean answer to that question until I downloaded the Resmed part# catalog. The previous reply seemed a tad incorrect. (I acknowledged that it was an old thread) :?: I never said it was a problem. I mentioned it because people have a habit of seeing a post and ...

goodman wrote: ↑

Tue May 21, 2024 9:55 am

Hows this

Can you see anything??? We can't.

Zombie thread alert folks.
Watch what you are replying to if you decide to reply.

Most likely they will supply the ResMed AirCurve 10 ASV, The AirCurve 11 ASV was just released a short time ago and most likely that model isn't so readily available just yet. https://www.resmed.com/en-us/healthcare-professional/products-and-support/devices/aircurve-10-asv/ https://www.resmed.com/en...

Any leak no matter how big or how little it is that WAKES YOU UP is unacceptable because it is disturbing your sleep for one thing. After that if you are sleeping through the leaks then ResMed's line in the sand is 24 L/min for the beginning of large leak territory and IMHO that's an ultra conservat...

https://www.cpaptalk.com/viewtopic/t188210/Anyone-else-experiencing-connection-problems-here-on-the-forum.html Anyone still experiencing the connection or error message issue please document it at the above thread. And this thread not turning into total bananas is likely the only upside to the extre...

He's fine.
Just very busy with some other stuff.

So I used the Solo for about 10 nights. My thoughts.... Nice little mask and some people will love it and some won't. Tis the way of any mask out there. Lovers and haters and a person is just going to have to try it to see which way they will lean. Please don't go asking me how you will like it (or ...

It's hard enough to diagnose UARS with RERAs recorded.....Impossible without that data point.

Over a dozen of the error message already happening.
Yesterday well over 100.
Sometimes slow to load and sometimes not so slow.

You might add your machine model to your comments section of your profile since it isn't available from the equipment menu. Will avoid confusion later.
Just don't choose a machine from the drop down menu.

Ahhhhh.
Then you simply won't have the flow limitation graph to evaluate since you don't have auto mode.

I don't know if ResMed is shipping the Air Curve 11 machines with a SD card included or not but it has a spot for a SD card.

See page 5

https://document.resmed.com/documents/p ... _multi.pdf

I believe that when using the AirCurve in S mode (fixed bilevel pressures) that the FL sensor is disabled and that's why no flow limitation graph. It's my understanding that a person needs to use Auto Bilevel mode to get FL graphs. You can still use the same settings if you wish ....just change to A...

viewtopic/t188210/Anyone-else-experienc ... forum.html

Probably not your phone. Others reporting slow downs and repeated error message.

alancalan wrote: ↑

Wed May 15, 2024 9:06 am

Have any of you noticed that this site is slowing down or is it my phone?