Rescan 3.5 vs 3.7
-
- Posts: 5
- Joined: Sat Nov 29, 2008 8:33 am
- Location: Alberta, Canada
Rescan 3.5 vs 3.7
I am currently successfully using Rescan 3.5 on Windows 7 (64 bit) and it is working exactly the same as on Windows XP. I was wondering if there would be any advantage upgrading to 3.7...is there any more data, graphs, etc available on 3.7 ? Thanks in advance to all.
_________________
Humidifier: HumidAire H4i™ Heated Humidifier |
Additional Comments: ResMed VPAP ST on VAuto, Min 9cm, Max 15cm, PS 3.6cm, Rescan 3.5, Activa, Activa LT |
Re: Rescan 3.5 vs 3.7
I downloaded Rescan 3.7 this morning and installed it on Windows 7 - 32 Bit
I received the message..."Platform not supported" but it apparently installed.
I can't provide any further information until the card reader is received. I'm assuming Rescan
3.7 will work even with the above message.
Note: The drivers for the software are "ACR38"
I received the message..."Platform not supported" but it apparently installed.
I can't provide any further information until the card reader is received. I'm assuming Rescan
3.7 will work even with the above message.
Note: The drivers for the software are "ACR38"
Re: Rescan 3.5 vs 3.7
I'm using rescan 3.7 with windows 7 64 bit. I also received the same error but it installed and works just fine.
-
- Posts: 223
- Joined: Thu Jun 19, 2008 2:31 pm
Re: Rescan 3.5 vs 3.7
As far as I can see, there's no difference between the two. Try e-mailing ResMed. There must be a difference, otherwise why would they came out with a new version. Maybe they eliminated some bugs.
Ed
Ed
ResMed Airsense 10 Autoset APAP
ResMed Mirage Quattro FFM
Backup ResMed S9
ResMed Mirage Quattro FFM
Backup ResMed S9