Ramp Disabled
-
- Posts: 59
- Joined: Sat Apr 04, 2020 1:33 pm
Ramp Disabled
I have a secondhand Resmed Airsense 10 Auto (that I fully took apart and cleaned). Contrary to every thread I found about turning Ramp OFF, I cannot turn mine on. It's grayed out.
The only alteration I made out of privacy concerns but dont know why that would have an impact was I removed the modem.
Is there some Secret Menu (within Clinical or otherwise) to do some sort of Reset or is it possibly disabled by the DME/Doctor of the previous owner?
The only alteration I made out of privacy concerns but dont know why that would have an impact was I removed the modem.
Is there some Secret Menu (within Clinical or otherwise) to do some sort of Reset or is it possibly disabled by the DME/Doctor of the previous owner?
_________________
Machine: ResMed AirSense™ 10 AutoSet™ CPAP Machine with HumidAir™ Heated Humidifier |
Mask: ResMed AirFit™ F30 Full Face CPAP Mask with Headgear |
Additional Comments: Note: (F30i not F30 mask) + Heated Tubing |
- ChicagoGranny
- Posts: 14771
- Joined: Sun Jan 29, 2012 1:43 pm
- Location: USA
Re: Ramp Disabled
Press the dial button and the home button at the same time. This will get you into the clinical menu and the settings.
"It's not the number of breaths we take, it's the number of moments that take our breath away."
Cuando cuentes cuentos, cuenta cuántas cuentos cuentas.
Cuando cuentes cuentos, cuenta cuántas cuentos cuentas.
- Dog Slobber
- Posts: 4064
- Joined: Thu Feb 15, 2018 2:05 pm
- Location: Ontario, Canada
Re: Ramp Disabled
Prior to the AirSense 10 and the proliferation of OTA configuration, providers "remotely" configured devices by:
Does the Air 10 still have an SD Card in it?
I suspect what has been happening is:
- Configure device using ResScan
- Save config to SD Card
- Give SD Card to patient
- Patient INserted SD Card into device
- Device is then updated according to the settings saved on the SD Card
Does the Air 10 still have an SD Card in it?
I suspect what has been happening is:
- The device got it's config from the SD Card
- It then called home using the Modem which updated the config, allowing access to the Ramp
- When you removed the modem, it could no longer call home to update the config, leaving the ramp feature in it's unavailable state.
_________________
Machine: AirCurve™ 10 VAuto BiLevel Machine with HumidAir™ Heated Humidifier |
Mask: AirFit™ P30i Nasal Pillow CPAP Mask with Headgear Starter Pack |
Additional Comments: Min EPAP: 8.2, Max IPAP: 25, PS:4 |
Re: Ramp Disabled
Is it yours, or the fromer owner's?
No being as knowledgeable as Dog Slobber, if the SD card was not mine, I would format it in my computer.
Or, if you're concerned about which computer in has been in before, get a new one of your very own.
If it was my own SD card, and somehow got updated when the modem was still used by the APAP, I would format the card before reinserting it into the machine after I had set the machine to its factory setup.
_________________
Mask: AirFit™ P10 Nasal Pillow CPAP Mask with Headgear |
Additional Comments: Machine: Resmed AirSense10 for Her with Climateline heated hose ; alternating masks. |
And now here is my secret, a very simple secret; it is only with the heart that one can see rightly, what is essential is invisible to the eye.
Antoine de Saint-Exupery
Good advice is compromised by missing data
Forum member Dog Slobber Nov. 2023
Antoine de Saint-Exupery
Good advice is compromised by missing data
Forum member Dog Slobber Nov. 2023
- Dog Slobber
- Posts: 4064
- Joined: Thu Feb 15, 2018 2:05 pm
- Location: Ontario, Canada
Re: Ramp Disabled
Kind of off-topic, but also kind of relevant because many of us buy used machines and many of them come with the previous owners data.ozij wrote: ↑Thu Jul 11, 2024 9:14 amif the SD card was not mine, I would format it in my computer.
Or, if you're concerned about which computer in has been in before, get a new one of your very own.
If it was my own SD card, and somehow got updated when the modem was still used by the APAP, I would format the card before reinserting it into the machine after I had set the machine to its factory setup.
I too, always reformat SD Cards from used machines. But with my curiosity I always load the data into OSCAR and have a peek.
_________________
Machine: AirCurve™ 10 VAuto BiLevel Machine with HumidAir™ Heated Humidifier |
Mask: AirFit™ P30i Nasal Pillow CPAP Mask with Headgear Starter Pack |
Additional Comments: Min EPAP: 8.2, Max IPAP: 25, PS:4 |
- chunkyfrog
- Posts: 34534
- Joined: Mon Jul 12, 2010 5:10 pm
- Location: Nowhere special--this year in particular.
Re: Ramp Disabled
Of course you would!Dog Slobber wrote: ↑Thu Jul 11, 2024 9:36 am. . .
But with my curiosity I always load the data into OSCAR and have a peek.
Me too.
_________________
Mask: AirFit™ P10 For Her Nasal Pillow CPAP Mask with Headgear |
Additional Comments: Airsense 10 Autoset for Her |
-
- Posts: 59
- Joined: Sat Apr 04, 2020 1:33 pm
Re: Ramp Disabled
@ChicagoGranny
As mentioned I am aware of the clinical menu. I was asking if there was a hidden menu within in it.
@Dog Slobber
I was hoping that's not l the case (Rescan) but hope it is as you mentioned not written to flash and only the SD but IRRC it didn't come with an SD card. Will try a factory reset before bed. We don't have anything to write to the machines, only read IE OSCAR right?
@ozij
This looks like one of my cards. I don't think the elderly lady I bought it from would have a UHS3 rated card in it.
@Dog Slobber and @chunkyfrog
If it had the original SD I would have probably only looked to see how a DMEs interpretation of sleep data and corresponding settings would have correlated to what I would have set based on OSCAR data.
As mentioned I am aware of the clinical menu. I was asking if there was a hidden menu within in it.
@Dog Slobber
I was hoping that's not l the case (Rescan) but hope it is as you mentioned not written to flash and only the SD but IRRC it didn't come with an SD card. Will try a factory reset before bed. We don't have anything to write to the machines, only read IE OSCAR right?
@ozij
This looks like one of my cards. I don't think the elderly lady I bought it from would have a UHS3 rated card in it.
@Dog Slobber and @chunkyfrog
If it had the original SD I would have probably only looked to see how a DMEs interpretation of sleep data and corresponding settings would have correlated to what I would have set based on OSCAR data.
_________________
Machine: ResMed AirSense™ 10 AutoSet™ CPAP Machine with HumidAir™ Heated Humidifier |
Mask: ResMed AirFit™ F30 Full Face CPAP Mask with Headgear |
Additional Comments: Note: (F30i not F30 mask) + Heated Tubing |
Last edited by SyCoREAPER on Thu Jul 11, 2024 11:51 pm, edited 1 time in total.
-
- Posts: 59
- Joined: Sat Apr 04, 2020 1:33 pm
Re: Ramp Disabled
Well that's peculiar. After popping the card out with the machine on (which I don't usually do), it's available.
Go figure.
Go figure.
_________________
Machine: ResMed AirSense™ 10 AutoSet™ CPAP Machine with HumidAir™ Heated Humidifier |
Mask: ResMed AirFit™ F30 Full Face CPAP Mask with Headgear |
Additional Comments: Note: (F30i not F30 mask) + Heated Tubing |
- Dog Slobber
- Posts: 4064
- Joined: Thu Feb 15, 2018 2:05 pm
- Location: Ontario, Canada
Re: Ramp Disabled
Looks like, as stated in my first post, there is a ResScan created config file on the SD Card.SyCoREAPER wrote: ↑Thu Jul 11, 2024 11:37 pmWell that's peculiar. After popping the card out with the machine on (which I don't usually do), it's available.
Go figure.
On the SD Card there should be a directory called Settings with some settings files in it. You can either delete that directory or format the SD Card and it won't bother you again.
_________________
Machine: AirCurve™ 10 VAuto BiLevel Machine with HumidAir™ Heated Humidifier |
Mask: AirFit™ P30i Nasal Pillow CPAP Mask with Headgear Starter Pack |
Additional Comments: Min EPAP: 8.2, Max IPAP: 25, PS:4 |
-
- Posts: 59
- Joined: Sat Apr 04, 2020 1:33 pm
Re: Ramp Disabled
Thats what's odd though. I didn't delete anything. Maybe it's if it cold boots with the card in?Dog Slobber wrote: ↑Fri Jul 12, 2024 6:15 am
Looks like, as stated in my first post, there is a ResScan created config file on the SD Card.
On the SD Card there should be a directory called Settings with some settings files in it. You can either delete that directory or format the SD Card and it won't bother you again.
I'll be taking a deeper look at the folders later but just thought it odd that removing the card and putting it back in re-enabled it.
_________________
Machine: ResMed AirSense™ 10 AutoSet™ CPAP Machine with HumidAir™ Heated Humidifier |
Mask: ResMed AirFit™ F30 Full Face CPAP Mask with Headgear |
Additional Comments: Note: (F30i not F30 mask) + Heated Tubing |