help with intellipap

[dohdohbah]

a new user here, any where i can find step by step instructions on how to generate a smart code to read my sleep data? much appreciated!

[Pugsy]

Don't use that machine and the only directions I know of are these here
https://www.cpap.com/cpap-machine/devil ... tflex.html

If you don't know how to get to the smart codes on the LCD machine perhaps your manual explains how.
If you don't have the manual you can request it here.
http://www.apneaboard.com/adjust-cpap-p ... tup-manual

[Slartybartfast]

I have one but it's 1100 miles away right now. I think you just push the little right arrow button once and the smart code will appear. Then push the down arrow and it will scroll through 1 day, 7 day, etc.

Here's the page with the link to the SmartCode report generator from DeVilbiss: http://www.devilbisshealthcare.com/prod ... /smartcode It's really a pretty cool way to get your numbers without mucking about with the fancy software.

IntelliPAP Standard Plus, AutoAdjust, Bilevel S
and AutoBilevel
1.Make sure IntelliPAP is plugged in and turned on
2. Push the left-arrow twice
3. Read Adherence Score
(If Adherence Score is above 70% proceed
with next steps, otherwise coach the
patient and schedule a follow-up call)
4. Push the right-arrow once
5. Push the down-arrow three times until the 90-day
code is displayed and read the code (optionally
collect the other codes for comprehensive data)

[Julie]

Hi - every a.m. I just put the 'delay' button twice, copy the code and enter it either on cpap.com's place for it or on DeVilbiss's site - but remember to hit it once again after you've copied the code so it goes to 'off'.

[dohdohbah]

thank you all for your input, very useful! I now have another question, if I want to change the APAP mode to CPAP mode, how do it do it? I figure that I only set the system to CM H20 to 7, it will serve my purpose. Tks for your help in advance!

[chunkyfrog]

Re-check Pugsy's links above.