how to find the firmware version and run hours on S9

blomasky · Post by **blomasky** » Mon Jan 21, 2013 4:19 pm

My dme just dropped of a shiny new (I think) S9 autoset. (I notice the 90w power supply is much smaller than one that came with an S9 I got 6 months ago. Where on the clinicians menu (or wherever) can I find both the total run hours and the firmware version?

Thanks
Bruce

archangle · Post by **archangle** » Mon Jan 21, 2013 5:52 pm

blomasky wrote:My dme just dropped of a shiny new (I think) S9 autoset. (I notice the 90w power supply is much smaller than one that came with an S9 I got 6 months ago. Where on the clinicians menu (or wherever) can I find both the total run hours and the firmware version?

Thanks
Bruce

I believe some of this info appears in different places in the menu depending on the version of the software, so yours may not be in the same place.

In my case, you don't actually need the clinician's menu

Press info - service - SW shows you the firmware version. (SX474-0602)

Back to home menu or timeout

Press and hold Info and Setup until the menu changes into the advanced info menu
Sleep report - Scroll down to "run hours" - 2605 hours.

Note that "Run hours" is the machine hours, not "Used hours." Also, run hours includes the cool down cycle at the end of each session you have, so the number will be higher than expected.

blomasky · Post by **blomasky** » Tue Jan 22, 2013 7:15 am

thanks, guess I was just blind. OK, happy with the new machine, new firmware and smaller power brick (for when traveling.) life is good! Well as good as I can expect!

bruce

StuUnderPressure · Post by **StuUnderPressure** » Tue Jan 22, 2013 10:32 am

blomasky wrote:thanks, guess I was just blind. OK, happy with the new machine, new firmware and smaller power brick (for when traveling.) life is good! Well as good as I can expect!

bruce

So, what is the Software Version?

cosmo · Post by **cosmo** » Tue Jan 22, 2013 10:39 am

Is the brick smaller than the top left one?

MagsterMile · Post by **MagsterMile** » Tue Jan 22, 2013 2:35 pm

Cosmo:
that brick looks like the one I have plus there is a humidifer attached to it.

cosmo · Post by **cosmo** » Tue Jan 22, 2013 2:44 pm

Unit made in Singapore?

This was mine. There was 0 hours when I did get it.

This info below was from a different thread someone noted.

SW - Software Version (of the S9 AutoSet)
BID - Boot loader ID
VID - Variant ID
RID - Regional Variant ID
HID - Humidifier Software ID

viewtopic.php?f=1&t=84556&p=769883&hilit=+dme#p769421

how to find the firmware version and run hours on S9

how to find the firmware version and run hours on S9

Re: how to find the firmware version and run hours on S9

Re: how to find the firmware version and run hours on S9

Re: how to find the firmware version and run hours on S9

Re: how to find the firmware version and run hours on S9

Re: how to find the firmware version and run hours on S9

Re: how to find the firmware version and run hours on S9